skip to main text

2801

Cause

The document is jammed in the ADF.

Action

Remove the document following the procedure below.

Important

  • The power cannot be turned off while the machine is sending or receiving a fax, or when the received fax or the unsent fax are stored in the machine's memory.

    Make sure if the machine completed sending or receiving all the faxes before disconnecting the power cord.

    If you unplug the power cord, all the faxes stored in the machine's memory are deleted.

  • If the original remains in the ADF by pressing the Stop button while the machine is scanning the document:

    If you press the Stop button during scanning then the document remained in the ADF, the message about the paper remained in the ADF appears on the LCD. Press the OK button so that the remaining document is automatically fed out.

  • If the original is jammed in the ADF:

    Remove the document following the procedure below.

    1. If printing is in progress, press the Stop button.

    2. Turn off the machine.

    3. If a multi-page document is loaded, remove any pages other than the jammed page from the ADF, then open the document feeder cover.

    4. Pull out the jammed document from the ADF.

    5. Close the document feeder cover, then turn on the machine.

      When rescanning the document after clearing the error, rescan it from the first page.

    If you cannot remove the document or the document tears inside the machine, or if the document jam error continues after removing the document, contact the service center.

    Note

    • The document may not feed properly depending on the media type, or your environment, such as when the temperature and humidity are either too high or too low.

      In this case, reduce the number of document pages to approximately half of the loading capacity.

      If the document still jams, use the platen glass instead.

  • If the original is jammed in the ADF (from the paper feed side):

    If the document is jammed in the document output slot, close the document tray as shown in the figure below and pull out the document.

    When rescanning the document after clearing the error, rescan it from the first page.

    If you cannot remove the document or the document tears inside the machine, or if the document jam error continues after removing the document, contact the service center.