skip to main text

Reinstalling the Printer

The basic workflow for reinstalling the printer is as follows.

Assemble the stand (Option)

  1. If you want to use the printer stand, assemble the printer stand.

    Note

    • For instructions on assembling and installing the printer stand, see the Printer Stand Setup Guide.

Install the printer

  1. Remove the packed printer from the box and bag.

    Caution

    • Moving the printer requires two people. Be careful to avoid back strain and other injuries.

    • When moving the printer, firmly grasp the carrying grips. The printer may be unsteady if you hold it at other positions, which poses a risk of injury from dropping the printer.

  2. When using the printer stand, attach the printer to the assembled stand.

  3. When using a desktop basket, attach the desktop basket to the printer.

    Important

    • The printer stand and desktop basket cannot be installed at the same time.

    Note

    • For instructions on installing the desktop basket, see the Desktop Basket Setup Guide.

  4. Install the roll holder support.

    Depending on your printer, there may be one or two knurled screws.

  5. Plug the power cord into the power cord connector on the back of the printer.

  6. Plug the power plug into an outlet.

  7. Press ON button to turn on printer.

  8. Load paper in the printer.

  9. Install the software.

    Note that the driver installation procedure varies depending on the type of connection.

    Important

    • When the printer is connected to a network (via TCP/IP), the printer's IP address may be changed if you reinstall the printer.

      In this case, be sure to reconfigure the printer's IP address.