skip to main text

Width correction

Corrects pen widths in accordance with a specific correction setting. Correction settings can be configured for two groups: Black/gray and Color.

Select and apply the correction amount according to the pen color when performing a line drawing command of HP-GL/2 data.

Select this setting item from Device settings > Print settings > HP-GL/2 print settings > Line & pen manager.

Note

  • This setting is not applied for the white pen, which has the same RGB values (255).
  • This setting is applied to vector data line widths.
  • When this setting is a minus value, it is not applied to fine lines of widths that are less than the minimum line width of the printer.
  • If the setting value is smaller than 1 dot, the value of 1 dot width is applied.
  • When ON is selected for Thicken fine lines, the resulting line may be thicker than the specified setting.
  • Black/gray

    For configuring the correction setting of black and gray line widths.

    A value within the range of -20 to +20 can be specified. 1 unit of the correction value is equivalent to 0.025 mm.

  • Color

    For configuring the correction setting of color line widths.

    A value within the range of -20 to +20 can be specified. 1 unit of the correction value is equivalent to 0.025 mm.

LINE WIDTH CORRECTION EXAMPLE

  • Negative (-) setting

  • Positive (+) setting